Casting Plates
(click here)

Vibration Isolation
(click here)
_  
  ENGINE TILTING TABLE
MULTI-AXIS SHAKING TABLE
AXLE TEST FIXTURE
- Standard Fixture EAB
- Suspension Development
- 6 Degree of Freedom (6 DoF)
- Acoustics and Modal Analysis
- Kinematics & Compliance
VIMM (VEHICLE INERTIA
MEASURING SYSTEM)
(NEW)
EXHAUST TEST RIG FIXTURE
  X-Y POSITIONING SYSTEMS
- 4-Poster Test System
- Head Impact Pendulum
- Driveline Test System
TORSIONAL SYSTEMS
PORTAL FRAMES
STEEL FLOORS
MAINTANANCE PLATFORM
ELEVATING TABLE
SPRING CLAMPS
FINITE ELEMENT ANALYSIS
SOFTWARE XiCon
SOFTWARE XiCon OIS
INTRODUCTION
MOCOKIT 25 (up to 5.5 kip)
- EXAMPLES
- COMPONENT LAYOUT
- COMPONENTS
MOCOKIT 65 (up to 14 kip)
- EXAMPLES
- COMPONENT LAYOUT
- COMPONENTS
MOCOKIT 250 (up to 55 kip)
- EXAMPLES
- COMPONENT LAYOUT
- COMPONENTS

Multi-Axial Shaking Table

The shaking table is frequently employed with axial test rigs to accommodate test specimens. It must be designed to withstand the high loads of dynamic testing. This means it must possess high strength with lowest possible mass and also be free of natural frequencies in the test frequency range.

In accordance with customer specifications in terms of geometrical dimensions and actuator application points we design tables adjusted to the flow of forces and which possess natural frequencies above the highest test frequency. The top can be equipped with slots or thread inserts as required.

     
_For more information: E-mail: contact@cfm-itbona.com Phone: +1 (952) 942-6104 FAX: +1 (952) 942-6106
   


 
Copyright@2002 - 2006 CFM-ITBONA LLC. All Rights reserved
CFM-ITBONA LLC, 4282 SHORELINE DRIVE, SPRING PARK, MN 55384, USA