Vibration Isolation
(click here)

Test Fixtures
(click here)
_  
BASE PLATES

- OVERVIEW & EXAMPLES
- SIZES (METRIC & US)

- SURFACE ACCURACY DIN 876

- MACHINED T-SLOTS DIN 650

- ANCHORS & LEVELING

- EXAMPLES
- INSTALLATION
VIBRATION ISOLATION
FLOOR CLAMPING RAILS
SURFACE PLATES
STRAIGHTENING PLATES
BLUEING PLATES
MEASURING MACH PLATES
PLATE SUPPORTS
- SUPORT FRAMES TYPE LU
- SUPPORT FRAMES TYPE UU
SURFACE ACCURACY DIN 876 
ANGLE PLATES
- TYPE WN
- TYPE WS/WSN
- SPECIAL DESIGNS
T-SLOT TABLES
MACHINE TABLES
BOX CUBES
BOX TABLES
FORGE AND SWAGE PLATES
PARALLEL VEES
CUSTOM DESIGNS

SURFACE ACCURACY DIN 876
TOLERANCES

MACHINED T-SLOTS DIN 650
T-NUTS, BOLTS & WASHERS
T-SLOT COVERS
NON-SHRINKING GROUTS
EXAMPLES

Parallel Vees, Type PAS

STOLLE parallel vees are supplied with different sized vees in each of the four faces, allowing seating to accomodate different shaft sizes exactly.
The vees are made to specific sizes so that even heavier shafts can be accomodated without difficulty. These blocks are milled as matched pairs to DIN 876 / II.
 

V-Blocks, Type PRI

Clamping features on base make STOLLE vee-blocks ideal for supporting shafts during machine operations or for measuring round work pieces. Supplied with a single vee of 90 degrees machined parallel to the base, available as either normal or fine machined finish.




_For more information: E-mail: contact@cfm-itbona.com Phone:t +1 (952) 942-6104 FAX: +1 (952) 942-6106
Copyright@2002 - 2006 CFM-ITBONA LLC. All Rights reserved
CFM-ITBONA LLC, 4282 SHORELINE DRIVE, SPRING PARK, MN 55384, USA
CFM-ITBONA HOME GOTO VIBRATION ISOLATION GOTO TEST FIXTURES GOTO STOLLE HOME